Installing hot film air mass meter

• Insert and install the hot film air mass meter (2).
• Tighten screws (arrows).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Hot film air-mass meter to intake filter housing
  Screw TS4x16	Tightening torque	1.4 Nm

• Connect and lock the connector (1).
• The connector (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

For replacement: Reset adaptation values 

• Reset the adaptation values with the diagnostic system:
  • Drive
  • DDE/DME
  • Reset adaptations
  • Delete adaptations