Installing the throttle body

Replace sealing ring (1).
Parts: Sealing ring
Guide in and install sealing ring (1) on intake plenum (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Replace sealing ring (1).
Parts: Sealing ring
Insert and install new sealing ring (1) on the throttle body.

Courtesy of BMW OF NORTH AMERICA, INC.
Guide in and install throttle body (2) on throttle valve (3) in the arrow direction.
Ensure that locks (1) engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.
Thread in and install the throttle valve.

Tighten down screws (2).

TIGHTENING TORQUE SPECIFICATIONS

Throttle body to intake plenum
6x50	Tightening torque	7 Nm

If installed: Connect and lock the engine ventilation line (1).
The engine ventilation line (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.
Check seal (1) for damage and replace seal (1) as needed.
Parts: Gasket

Courtesy of BMW OF NORTH AMERICA, INC.

Replacing the damaged seal

NOTE: TECHNICAL INFORMATION
Use of sharp or pointy tools for installation or removal is prohibited.

Remove damaged seal.
Clean the gasket groove (1) with a dry cloth.
The gasket groove (1) must be clean.

Courtesy of BMW OF NORTH AMERICA, INC.
Replace gasket.
Parts: Gasket
Install the seal dry without lubricant or mounting agent.
NOTE: TECHNICAL INFORMATION
Incorrect assembly is possible. Ensure correct installation position.
Thread in seal and install.
Make sure that the seal is installed correctly in the gasket groove (1).
Make sure that the sealing lip (2) is directed to the inside as shown.

Courtesy of BMW OF NORTH AMERICA, INC.

Detach locks (1) from the holders in the arrow direction.

Courtesy of BMW OF NORTH AMERICA, INC.
Connect and lock connector (1) on the boost pressure sensor.
Connect and lock the connector (2) on the throttle valve.
Make sure that the connector (1) and (2) engages audibly.
Insert and install pressure pipe (3) on the throttle body.
Make sure the pressure pipe (3) engages audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work