34 41 164 Removing and installing/replacing right parking brake Bowden cable (Cooper 4-door hatchback and Cooper 2-door hatchback 2020-2023, except EV)

Preliminary work needed: 

• READ AND COMPLY WITH GENERAL INFORMATION .
• Remove WHEEL .
• Removing the TANK COVER on the right.
• Release the heat shield.

Release bellows on parking brake lever.

Release adjusting stand (1) for parking brake Bowden cable.

Courtesy of BMW OF NORTH AMERICA, INC.

Detach retaining clip (1) in arrow direction.

Disengage parking brake Bowden cable (2) from operating lever (3) at brake caliper.

Feed out parking brake Bowden cable (2) downwards.

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten left parking brake Bowden cable (1) in connector (2) in arrow direction and detach.

Courtesy of BMW OF NORTH AMERICA, INC.

Detach parking brake Bowden cable from holder (1).

Press down retaining lugs (2) and remove parking brake Bowden cable (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Attach parking brake Bowden cable to holder (1).

Install parking brake Bowden cable (3) in holder.

Retaining lugs (2) must be fully engaged.

Courtesy of BMW OF NORTH AMERICA, INC.

Insert left parking brake Bowden cable (1) into connector (2) in arrow direction and lock up to stop.

Courtesy of BMW OF NORTH AMERICA, INC.

Feed in parking brake Bowden cable (2) from below.

Mount locking clip (3).

Engage parking brake Bowden cable (2) in operating lever (1) on brake caliper.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Mounting the TANK COVER on the right.
• Fit heat shield.
• Remove WHEEL .
• Adjust PARKING BRAKE .