3112 Wishbone And Strut With Rubber Mount
3112 WISHBONE - TIGHTENING TORQUE SPECIFICATION
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Wishbone to swivel bearing | F54/F55/F56/F57/F60 | M10 | Exclusively use the screw to tighten! Replace screw and nut. |
60 Nm |
| 2AZ Wishbone to front axle support | F54/F55/F56/F57/F60 | M12 | Tighten in normal position! Replace the screw and the square nut. Joining torque Angle of rotation |
100 Nm 90° |
| 3AZ Holder, wishbone rubber mount, to front axle support | F54/F55/F56/F57/F60 | M12 | Replace screw. Observe installation position of the screws - different lengths! |
100 Nm |
| 4AZ Holder, wishbone rubber mount, to body | F54/F55/F56/F57/F60 | M10 | Replace screws. Joining torque Angle of rotation |
56 Nm 90° |