Install the impact absorber
NOTE:
TECHNICAL INFORMATION
Notes on the active pedestrian protection are a fundamental requirement for these repair instructions and must be complied with at all times.
For additional information see: 41 00... PROCEDURE FOR VEHICLES WITH ACTIVE PEDESTRIAN PROTECTION AFTER AN ACCIDENT
Notes on the active pedestrian protection are a fundamental requirement for these repair instructions and must be complied with at all times.
For additional information see: 41 00... PROCEDURE FOR VEHICLES WITH ACTIVE PEDESTRIAN PROTECTION AFTER AN ACCIDENT
- Check impact absorber (2)
for damage.
Replace damaged impact absorber (2) .
- Replace pedestrian protection sensor if required.
After an accident, the pedestrian protection sensor (1) must always be replaced.
- Insert the pedestrian protection sensor (1)
into the impact absorber (2)
.
The pedestrian protection sensor must be routed correctly.
- Carefully attach the impact absorber (2) at the bottom and then press on the top.
- Connect connectors (1)
and lock.