Securing the steering shaft at the bottom on the steering gear

Clean the screw thread In universal joint to remove all remnants of screw locking agent.
Swivel the universal joint (2) in arrow direction on to the steering gear.
Replace the screw (1) .
Parts: Screw

Tighten down screw (1) .

TIGHTENING TORQUE SPECIFICATIONS

Lower steering shaft to steering gear
M10 Clean screw thread and remove remains of screw locking agent. Replace screw.	Tightening torque	28Nm

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The following step(s) must be performed if the listed component(s) is/are installed.

Tighten nuts (1) .

TIGHTENING TORQUE SPECIFICATIONS

Steering column cover panel to bulkhead
Plastic nut	Tightening torque	3Nm

Courtesy of BMW OF NORTH AMERICA, INC.