Secure mounted parts on the front axle support
NOTE:
Perform the steps on the right and left side.
- Replace screws (1)
.
Parts: Screws
- Tighten the screws (1)
.TIGHTENING TORQUE SPECIFICATIONS
Holder, wishbone rubber mount, to body M10 screw Replace screw. Joining torque 56Nm Angle of rotation 90°1 - Position engine mount (3) on the front axle support (1) .
- Tighten down screw (2)
.TIGHTENING TORQUE SPECIFICATIONS
Holder with rubber mount to front axle support M12 screw 100Nm NOTE: Perform the steps on the right and left side. - Position lock (2) .
- Lock the fuse (1)
of the lock (2)
from the holder for the charge air cooler.
- Tighten down screws (1)
.TIGHTENING TORQUE SPECIFICATIONS
Bottom deformation element to adapter plate for front axle support Tightening torque 11.8Nm - Tighten down screws (1)
.TIGHTENING TORQUE SPECIFICATIONS
Bottom deformation element to adapter plate for front axle support Tightening torque 11.8Nm - Position the holder for the washer fluid reservoir (2) .
- Tighten down screws (3)
.TIGHTENING TORQUE SPECIFICATIONS
Washer fluid reservoir holder to adapter plate of front axle support Tightening torque 10Nm