Installing hot film air mass meter

• Insert and install the hot film air mass meter (2).
• Tighten screws (arrows).

  Courtesy of BMW OF NORTH AMERICA, INC.

  TIGHTENING TORQUES SPECIFICATION
  
  

  Hot film air-mass meter to intake filter housing
  Screw TS4x16	Tightening torque	1.4Nm

• Connect and lock the connector (1).

  The connector (1) must engage audibly.

For replacement: Reset adaptation values 

• Reset the adaptation values with the diagnostic system:
  • Drive
  • DDE/DME
  • Reset adaptations
  • Delete adaptations