Remove and install/replace seat height adjustment lever on left or right front seat (Countryman 2017-2023, except PHEV)
Special tools required:
IMPORTANT:
- Microencapsulated screws must be coated with Loctite if they are to be reused
Screw connection must be completed within 20 min. (start of harden)
Microencapsulated screws must not be retightened.
Thread of nut must be cleaned beforehand in event of repeated use
Removal:
Unclip cover (1) with special tool 2 298 505 .
Release screw (1) and remove lever (2).
Installation:
Position lever (2) and tighten screw (1).
Tightening torque 17 Nm .
Insert cover (1) at bottom and engage in upwards direction.