51 16 480 Removing and installing or replacing front grab handle (Countryman 2017-2023, except PHEV)
When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).
Removal:
Fold grab handle (1) downwards.
Disengage and remove locking clips (2) with angle screwdriver (3), as shown.
Release bottom and top release hook (1) with screwdriver.
Remove grab handle (2) and place to side.
Installation:
Insert grab handle (1) into body.
Engage locking clips (2) on both sides of grab handle (1).
NOTE:
Only after grab handle (1) is snapped in correctly can locking clips (2) be fully locked in position in grab handle (1).