26 12 011 Replacing grooved ball bearing in propeller shaft center bearing (Countryman base ALL4 AWD, Countryman S ALL4 AWD, Countryman JCW ALL4 AWD)

Special tools required: 

• 00 7 500
• 23 2 430 

Preliminary work needed: 

• Remove PROPELLER SHAFT CENTER BEARING .

Removal: 

Install special tool 00 7 500 between deep groove ball bearing (1) and propeller shaft (2).

Using a hydraulic press, force deep groove ball bearing (1) off propeller shaft (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Use special tool 23 2 430 to press new deep groove ball bearing (1) on to propeller shaft (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Install PROPELLER SHAFT CENTER BEARING .