34 21 295 Replacing rear left or right dust boot on brake caliper (Countryman 2017-2023, except PHEV)

Preliminary work needed :

Remove rear pads.

NOTE: Dust boot can be replaced without dismantling the brake caliper and without removing the piston.
Use original BMW repair kit.

Removal :

Remove dust boot (1) from brake caliper (2) in arrow direction with a suitable tool.

IMPORTANT: Dust boot must not be re-used!

Courtesy of BMW

Clean contact surface of dust boot at brake caliper housing (1) and piston groove (2) with a lint-free cloth.

IMPORTANT: Carefully check brake caliper housing, cylinder bore and brake piston for damage and corrosion!
Corroded or damaged components must be replaced!
The contact surface on the brake caliper housing must be dry and free of grease before installing the dust boot!

Courtesy of BMW

Installation :

Pull sealing lip (1) of dust boot over the brake piston until the dust boot (2) is properly seated in the brake piston groove.

Put dust boot (2) uniformly onto contact surface of brake caliper housing and uniformly push in.

IMPORTANT: The dust boot must be correctly lying against the entire circumference of the brake caliper housing and the brake piston groove.

Courtesy of BMW

Required follow-up work :

Install rear brake pads.

When the repair work is complete, please pay attention to the following:

Check brake pads and brake discs for wear.
Perform brake test on test stand
Perform test drive.