34 11 667 Precision-turning both front brake rotors on both sides (Countryman 2017-2023, except PHEV)
IMPORTANT:
Always precision-turn both sides of both brake discs on one axle.
Maximum machining dimension per friction ring side is 0.8 mm!
MINIMUM THICKNESS (MIN TH)
Brake discs of M models (Compound brake discs) must not be machined!
Only one brake pad set may be used up on brake discs which have been lathe-turned to MINIMUM THICKNESS (MIN TH) .
Maximum machining dimension per friction ring side is 0.8 mm!
MINIMUM THICKNESS (MIN TH)
Brake discs of M models (Compound brake discs) must not be machined!
Only one brake pad set may be used up on brake discs which have been lathe-turned to MINIMUM THICKNESS (MIN TH) .
Mobile brake disc lathe :
IMPORTANT:
Only
BMW-APPROVED BRAKE DISC LATHES
may be used!
In the case of mobile brake disc lathes, the brake caliper and the brake anchor plate must be removed.
The brake discs remain on the vehicle.
Please refer to the equipment manufacturer's operating instructions for the exact procedure.
After precision turning the brake discs, the DIFFERENCE IN THICKNESS must be measured with a micrometer (2) at 8 different points (1) approx. 10 mm (dimension A) from the outer edge of the disc!
PERMISSIBLE DIFFERENCE IN THICKNESS: REFER TO TECHNICAL DATA .