When replacing the seat frame: Remount components
Removing the LATCH anchor for the front passenger seat
NOTE:
The operations shown only for one side must be carried out on both sides.
- Drill out the blind rivets (1).
- Remove the LATCH anchor (2) for the front passenger seat.
Removing front lower strap
NOTE:
TECHNICAL INFORMATION
Different variants may be installed depending on the vehicle equipment.
Different variants may be installed depending on the vehicle equipment.
- Loosen screw (1).
- Unclip the cable clip (2).
- Feed the cable (1) out of the seat mechanism.
- Release cable tie (1).
- Carefully unlock the detents (markings).
- Thread the matching connector plugs (2) in the direction of the arrow out of the connector plug housings (3).
Installing the front lower strap
NOTE:
TECHNICAL INFORMATION
Clean all threaded belt connections with micro-encapsulated outer and internal threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength.
The screw connection must be completed within 10 minutes as hardening begins after this period.
Clean all threaded belt connections with micro-encapsulated outer and internal threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength.
The screw connection must be completed within 10 minutes as hardening begins after this period.
NOTE:
TECHNICAL INFORMATION
Different variants may be installed depending on the vehicle equipment.
Different variants may be installed depending on the vehicle equipment.
- Guide the associated connectors (1) into the connector housing (2) and clip them in.
- Fasten the cable (3) on the connector housing (2) using a cable tie.
- Hook the cable (1) into the seat mechanism.
- Replace the screw (1).
Parts: Screw
- Tighten down screw (1).
- Clip in the cable bracket (2).
Installing the ISOFIX anchor for the (front) passenger seat
- Position the ISOFIX anchor (2) for the (front) passenger seat correctly.
- Replace blind rivets (1).
Parts: Blind rivet
NOTE:
The operations shown only for one side must be carried out on both sides.
- Secure the ISOFIX anchor (2) for the (front) passenger seat with the blind rivets (1).