Install the left deformation element
- Insert the deformation element (5).
- Tighten down screws (2).TIGHTENING TORQUE SPECIFICATIONS
Deformation element, top, to engine carrier Renew screws. Joining torque 100Nm Angle of rotation 180° - Tighten down screws (3).TIGHTENING TORQUE SPECIFICATIONS
Lock support to deformation element 11.8Nm - Tighten the screws (1).TIGHTENING TORQUE SPECIFICATIONS
Vertical strut to deformation element Flat-head screw M6x20 Tightening torque 11.8Nm Hexagon screw Tightening torque 11.8Nm - Tighten down screws (4).TIGHTENING TORQUE SPECIFICATIONS
Air duct to deformation element, bottom 8Nm