51 14 012 Removing and installing/replacing rear MINI plate (Countryman 2017-2023, except PHEV)
Special tools required:
- 00 9 322
IMPORTANT:
THE NOTES ON COMPONENT BONDING WITH DOUBLE-SIDED ADHESIVE TAPE
serve as the basis for this repair instruction and must be observed without fail.
Removal:
Heat MINI plaque (1) with hot air blower and carefully lever out with special tool 00 9 322.
Installation:
Detach the Liner* from the adhesive tape (1) and place the MINI plaque over the guide pins (2) in the bores (3) of the trunk lid handle (4) and press down firmly.
* Liner is the protective film on a new MINI plaque.