Install the transfer box (VTG)

If the intermediate shaft (1) catches on the transfer box (VTG) (2) , replace the intermediate shaft (1) and the radial shaft seal in the automatic transmission or the manual transmission.

Courtesy of BMW OF NORTH AMERICA, INC.
Screw in the special tool 2 409 025 in the outer radial shaft seal.
Turn the screw on the special tool 2 409 025 until the outer radial shaft seal is pulled out.

Courtesy of BMW OF NORTH AMERICA, INC.
Insert the special tool 2 411 739 in the inner radial shaft seal.

Courtesy of BMW OF NORTH AMERICA, INC.
Screw in the special tool 2 411 739 in the inner radial shaft seal.
Turn the screw on the special tool 2 411 739 until the inner radial shaft seal is pulled out.

Courtesy of BMW OF NORTH AMERICA, INC.
Use special tools 2 408 152 and 2 413 037 to drive in the inner radial shaft seal up to the stop.

Courtesy of BMW OF NORTH AMERICA, INC.
Use special tools 2 413 037 and 2 408 150 to drive in the outer radial shaft seal up to the stop.

Courtesy of BMW OF NORTH AMERICA, INC.
If necessary, mount new intermediate shaft (1) on the drive flange of the automatic transmission or manual transmission.

Courtesy of BMW OF NORTH AMERICA, INC.
Evenly coat the inside of the output flange (arrows) with approximately 5 g grease.
CONSUMABLE SPECIFICATION

Lubricating grease Optitemp HT 1 LF 50 g, Tube 83230417754

Courtesy of BMW OF NORTH AMERICA, INC.
Install the transfer box (VTG).

Tighten down screws (1) .

TIGHTENING TORQUE SPECIFICATIONS

Transfer box to transmission
M10	Tightening torque	56Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screws (1) .

TIGHTENING TORQUE SPECIFICATIONS

Heat shield to transfer box
M6 Replace screws.	Tightening torque	6Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Checking transfer box oil level

NOTE: RISK OF DAMAGE
Damage to the transmission.
Damage to the transmission due to unapproved transmission oil.

Tighten the oil filler plug (1) .

TIGHTENING TORQUE SPECIFICATIONS

Oil filler plug to transfer box (VTG)
M18x1.5	Tightening torque	35Nm