64 53 551 Removing and installing/replacing capacitor (with desiccant insert) for heating and air conditioning system (Cooper 4-door hatchback and Cooper 2-door hatchback, 2020-2023)

Special tools required:

00 9 030

WARNING: Injury hazard!
Refrigerant circuit is under high pressure!
Avoid contact with refrigerant and refrigerant oil.
Read and comply with safety instructions:

Handling refrigerant. Refer to INSTRUCTIONS FOR HANDLING R1234YF REFRIGERANT (COOPER 4-DOOR HATCHBACK AND COOPER 2-DOOR HATCHBACK, 2020-2023) , NOTE FOR HANDLING R134A REFRIGERANT (COOPER 4-DOOR HATCHBACK AND COOPER 2-DOOR HATCHBACK, 2020-2023) , SAFETY INSTRUCTIONS FOR HANDLING REFRIGERANT R1234YF (COOPER 4-DOOR HATCHBACK AND COOPER 2-DOOR HATCHBACK, 2020-2023) and SAFETY INSTRUCTIONS FOR HANDLING TETRAFLUORETHANE REFRIGERANT R134A (COOPER 4-DOOR HATCHBACK AND COOPER 2-DOOR HATCHBACK, 2020-2023) .
HANDLING REFRIGERANT FLUID .

IMPORTANT: Risk of damage!
Restart engine only when air conditioning has been correctly filled.
FOLLOW INSTRUCTIONS FOR OPENING AND REPLACING PARTS IN REFRIGERANT CIRCUIT !

NOTE: Desiccant insert cannot be replaced separately.

Preliminary work needed:

REMOVAL:

Unscrew the screws (1).

Remove strut (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew the screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Remove screw (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Loosen screw (1).

Feed out air duct (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Remove screw (1).

Remove refrigerant line (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Press radiator slightly forwards from rear.

Unlock left and right detent (1).

Pull capacitor (2) slightly upwards.

Courtesy of BMW OF NORTH AMERICA, INC.

Loosen screw (1).

Remove capacitor (2).

Courtesy of BMW OF NORTH AMERICA, INC.

INSTALLATION:

Position capacitor (3).

Position refrigerant line (2).

Tighten down screws (1).

Tightening torque 64 53 3AZ .

NOTE: The fins on the radiator and condenser should not be damaged.
Replace sealing rings.
Use special tool 00 9 030 to install sealing rings without damaging them.

Courtesy of BMW OF NORTH AMERICA, INC.

Capacitor (2) must be engaged in detent (1) on left and right.

Courtesy of BMW OF NORTH AMERICA, INC.

Position refrigerant line (2).

Tighten screw (1).

Tightening torque 64 53 3AZ .

NOTE: Replace sealing rings.
Use special tool 00 9 030 to mount sealing rings without damaging them.

Courtesy of BMW OF NORTH AMERICA, INC.

Feed in air duct (2).

Tighten screw (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten screw (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Position strut (2).

Tighten down screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Required reworking:

EVACUATE AND FILLING A/C SYSTEM .
Install FRONT BUMPER COVER .
Install CROSS CONNECTION .
Install intake silencer housing