Check/add the oil level in the electric machine transmission
WARNING:
Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly
.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Observe safety instructions on raising the vehicle using a vehicle hoist.
- For additional information see: 00 02 001 RAISING THE VEHICLE WITH A VEHICLE LIFT (COOPER SE ELECTRIC 2-DOOR HATCHBACK) .
NOTE:
TECHNICAL INFORMATION
It is paramount to replace the radial shaft seal each time the output shaft is removed.
It is paramount to replace the radial shaft seal each time the output shaft is removed.
Preliminary work
- Refer to REMOVING THE FRONT LEFT WHEEL .
- Refer to LOOSENING THE OUTPUT SHAFT FROM THE WHEEL BEARING .
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION .
- Refer to REMOVING LEFT OUTPUT SHAFT .
CAUTION:
Materials harmful to health
.
Contact with fluids harmful to health!
Contact with fluids harmful to health!
- Note and follow safety instructions on containers.
- Conduct all work in appropriate personal protective equipment only.
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
NOTE:
TECHNICAL INFORMATION
Collect and dispose of emerging fluids.
Observe country-specific waste disposal regulations.
Collect and dispose of emerging fluids.
Observe country-specific waste disposal regulations.
- Release oil drain plug (1).
- Drain and dispose of transmission oil.
- Replace sealing ring of the oil drain plug (1).
Parts: Sealing ring
- Clean oil drain plug (1), screw in and tighten.TIGHTENING TORQUE SPECIFICATIONS
Oil drain plug on electric machine transmission M16x1.5
Replace the sealing ring.35 Nm - Measure transmission oil.TECHNICAL DATA SPECIFICATION
Oil capacity, electric machine transmission Oil capacity 500 ml - Use a suitable auxiliary material (e.g. a syringe) to fill transmission oil through the opening (1) for the output shaft into the electric machine transmission.
Follow-up work
- Refer to REMOVING THE RADIAL SHAFT SEAL FOR THE LEFT-HAND OUTPUT SHAFT ON THE ELECTRIC MACHINE TRANSMISSION .
- Refer to INSTALLING THE RADIAL SHAFT SEAL FOR THE LEFT-HAND OUTPUT SHAFT ON THE ELECTRIC MACHINE TRANSMISSION .
- Refer to INSTALLING LEFT OUTPUT SHAFT .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to FASTENING THE OUTPUT SHAFT ON THE WHEEL BEARING .
- Refer to ATTACHING THE FRONT LEFT WHEEL .