Remove front bumper cover
NOTE:
RISK OF DAMAGE
Mechanical effects.
Paint damage.
Mechanical effects.
Paint damage.
- Mask those working areas at risk with yellow plastic adhesive tape.
- Remove and install heavy or bulky components with the aid of another person/other persons.
NOTE:
TECHNICAL INFORMATION
Notes for the gap dimensions of the body form the basis of this REP and it is mandatory to observe them.
For additional information see: BODY GAP DIMENSIONS (COOPER 4-DOOR HATCHBACK, 2020-2023)
Notes for the gap dimensions of the body form the basis of this REP and it is mandatory to observe them.
For additional information see: BODY GAP DIMENSIONS (COOPER 4-DOOR HATCHBACK, 2020-2023)
- Only in vehicles with build level up to: March 2021
NOTE:
Perform the steps on the right and left side.
- Release wheel arch trim (1) from detents (2) and clips (3).
- Only in vehicles with build level starting from:
March 2021
NOTE:
Perform the steps on the right and left side.
- Wheel arch trim (1) from the detents along the dotted line.
- Release wheel arch trim (1) from clips (2).
- Loosen screws (1).
NOTE:
Perform the steps on the right and left side.
- Loosen screws (1).
- Only in vehicles with build level up to: March 2021
- Loosen screws (1).
- Pull the bumper cover (2) slightly forward with the help of another person.
- Unlock and disconnect all plug connections depending on equipment specification.
- Remove the bumper panel (2) to the front with the help of another person.
- Only in vehicles with build level starting from: March 2021
- Loosen screws (1).
- Pull the bumper cover (2) slightly forward with the help of another person.
- Unlock and disconnect all plug connections depending on equipment specification.
- Remove the bumper panel (2) to the front with the help of another person.