41 34 060 Stripping Operation - Replace Tail Panel Outer Section And Inner Section Rep-Rep-RAF5641-4134060_RUESTEN_KLEBEN - V.3 (Cooper 4-Door Hatchback And 2-Door Hatchback, 2020-2023)
NOTE:
Owing to the different engine variants and equipment specifications, not all the components are taken into consideration.
The following list essentially represents the disassembly sequence.
The following list essentially represents the disassembly sequence.
- Remove complete exhaust system (FR number: 18 00 020)
- Remove heat shield for rear silencer
- Remove bumper cover (FRU number: 51 12 156)
- Remove bumper bracket (FRU number: 51 12 050)
- Remove guide for rear left and right bumper (job number: 51 12 828)
- Remove luggage compartment floor covering (FR number: 51 47 101)
- Remove left trunk wheel arch panel (FR number: 51 47 151)
- Remove right luggage compartment wheel arch trim panel (FR number: 51 47 161)
- Remove tail panel trim at top (FR number: 51 46 050)
- Remove and install trunk lid striker (FR number: 51 24 130)
- Release seal for rear lid
Release screws (1) and remove shaft (2).
Release detents and remove rear ventilation (1).
Release nuts and remove heat shield (2).
Release nuts and remove underbody planking (3).
Installation note:
The rear ventilation must not be damaged! (watertightness).
All detents must engage audibly.