54 13 004 Adjusting front or rear glass slide/tilt sunroof panel (Cooper 4-door hatchback and Cooper 2-door hatchback, 2020-2023)

Special tools required: 

• 00 9 315 
• 00 9 340 

Installation note: 

• Microencapsulated screws (Loctite) must be replaced and may not  be reused.
• Screw connection must be completed within 20 min. (start of hardening)
• Microencapsulated screws must not  be retightened.
• When using nuts multiple times, first clean the thread.

Height adjustment 

Courtesy of BMW OF NORTH AMERICA, INC.

• Front edge of glass slide/tilt sunroof panel at front 0 to 1 mm under roof edge
• Rear edge of front glass slide/tilt sunroof panel 0 to 1.5 mm above rear glass slide/tilt sunroof panel
• Rear edge of glass slide/tilt sunroof panel 0 to 1 mm above roof edge

Height adjustment: 

Check height of glass slide/tilt sunroof panel (1) in relation to body (2) with special tool 00 9 315  .

Press glass slide/tilt sunroof panel (1) at front and rear upwards or downwards until ideal position is reached.

Courtesy of BMW OF NORTH AMERICA, INC.

Distance setting: 

Use special tool 00 9 340  check that the gap between the glass slide/tilt sunroof panel and body is the same.

Slide special tool 00 9 340  or similar between gasket and insert. It must be possible to slide the card against the same level of resistance.

Slide glass slide/tilt sunroof panel towards front or rear until ideal position is reached.

Courtesy of BMW OF NORTH AMERICA, INC.

Adjusting glass slide/tilt sunroof panel at front: 

Carry out the following step on one side first and then the other (first left, then right or vice versa):

• Loosely screw in Torx screws (1) on left/right until glass slide/tilt sunroof panel (2) can just still be shifted
• Shift glass slide/tilt sunroof panel (2) as required
• Make sure all screws are tightened down.
• Tightening torque 54 12 4AZ .
• Repeat procedure on other side.

Courtesy of BMW OF NORTH AMERICA, INC.

Glass slide/tilt sunroof panel rear setting: 

Carry out the following step on one side first and then the other (first left, then right or vice versa):

• Loosely screw in torx screws (1) on left/right until glass slide/tilt sunroof panel (2) can just still be shifted
• Shift glass slide/tilt sunroof panel (2) as required
• Make sure all screws are tightened down.
• Tightening torque 54 12 4AZ .
• Repeat procedure on other side.

Courtesy of BMW OF NORTH AMERICA, INC.

Check function and adjustment.

Carry out INITIALIZATION .