3411 FRONT BRAKES TECHNICAL DATA (Cooper base 4-door hatchback)
3411 FRONT BRAKE F56 - TECHNICAL DATA SPECIFICATION
| Important: | ||
| New brake pads may only be installed if the brake disk thickness is greater than the minimum brake disc thickness. | ||
| Minimum brake disc thickness during general inspection (GI): | ||
| Nominal size thickness minus 2.4 mm | ||
| (Not applicable to perforated brake discs) | ||
| Perforated brake discs: | ||
| Nominal size thickness minus 1.6 mm | ||
| Depending on: | ||
| - Engine type | ||
| - Transmission version | ||
| - Equipment specification (e.g. maximum load increase, chassis official-use, national version, etc.) | ||
| different brake discs can be fitted | ||
| The brake discs must always be assigned by way of the relevant vehicle identification number and the applicable BMW parts catalogue! | ||
| Thickness difference in the friction surfaces of the brake disc | Max. mm | 0.01 |
| Nominal size (diameter x thickness) | mm | 280x22 |
| Nominal size (diameter x thickness) | mm | 294x22 |
| Minimum brake disc thickness stamped on brake disc chamber | mm | 20.4 |
| Pad wear warning from remaining brake pad thickness | mm | 3.7 |
BRAKE PERFORMANCE TESTING AS PART OF REGULAR PERIODIC VEHICLE INSPECTIONS AS PRESCRIBED - TECHNICAL DATA SPECIFICATION
| Model series | F55 |
| Base model | MINI ONE |
| Remarks | 5-door model |
| Approved gross vehicle weight (kg) | 1683 kg |
| Maximum brake pedal force to achieve a deceleration rate of 58 % in (N) | 170 N |
| Minimum front axle brake force ratio in % | 65.8 % |
| Minimum proportion of rear axle braking force in % | 13.1 % |
| Test area for brake pedal force (N) | 70 - 150 N |
3411 TECHNICAL DATA OVERVIEW
| Minimum brake disc thickness MIN TH (nominal dimension 335x30) | ||
| Minimum brake disc thickness MIN TH (brake disc 335x30) | ||
| 28.4 mm |
3411 FRONT BRAKE F55 - TECHNICAL DATA SPECIFICATION
| Important: | ||
| New brake pads may only be installed if the brake disk thickness is greater than the minimum brake disc thickness. | ||
| Minimum brake disc thickness during general inspection (GI): | ||
| Nominal size thickness minus 2.4 mm | ||
| (Not applicable to perforated brake discs) | ||
| Perforated brake discs: | ||
| Nominal size thickness minus 1.6 mm | ||
| Depending on: | ||
| - Engine type | ||
| - Transmission version | ||
| - Equipment specification (e.g. maximum load increase, chassis official-use, national version, etc.) | ||
| different brake discs can be fitted | ||
| The brake discs must always be identified by the relevant vehicle identification number and the applicable BMW parts catalogue! | ||
| Thickness difference in the friction surfaces of the brake disc | Max. mm | 0.01 |
| Nominal size (diameter x thickness) | mm | 280x22 |
| Nominal size (diameter x thickness) | mm | 294x22 |
| Minimum brake disc thickness stamped on brake disc chamber | mm | 20.4 |
| Pad wear warning from remaining brake pad thickness | mm | 3.7 |