Repair Solution For Straight Shank/Hexagon Rivet Nut Rep-Rep-RAGRP41-4105504 - V.4 (Cooper 4-Door Hatchback And 2-Door Hatchback, 2020-2023)
Protective measures!
- Wear safety goggles
- Wear protective gloves
Attention!
To prevent the material from tapering, do not drill out the rivet head.
- Carefully spot-drill rivet head with a larger drill bit/countersink
Attention!
Avoid paint damage
- Knock rivet head away with a chisel
- Punch through rivet shank into cavity, remove if necessary
- Clean component, eliminate paint damage if necessary
If the rivet shank can be removed:
Attention!
To avoid corrosion, stop chips/shavings with cavity sealant.
Please observe the notes on corrosion protection. Refer to PROCESSING OF 2K-PU-CAVITY FOAM REP-ALG-RAGRP41-4100X01 - V.2 (Cooper 4-door hatchback and 2-door hatchback, 2020-2023) .
- Preserving cavity
If the rivet shank cannot be removed:
WARNING: Injury hazard!
Please observe the NOTES ON CAVITY FOAM .Attention!
To avoid corrosion and rattling noises, stop chips/shavings and rivet nut shank with cavity foam.
Remove foam remnants with isohexane (cleaning benzene).
- Stop rivet shank by means of specific foaming
- Set rivet nut with hand rivet gunNOTE: Fit rivet nut as quickly as possibly ideally before the cavity foam hardens.
Hexagon head/straight shank rivet nut (up to thread M8) with hand rivet gun ZS308
Attention!
Follow manufacturer's operating instructions.
Make sure rivet nut correctly contacts component.
NOTE: According to the manufacturer, the tool shown is suitable for threads up to M8 (see S-Gate/dealer's equipment catalog).Hexagon head/straight shank rivet nut (up to thread M12) with hand rivet gun MB512
Attention!
Follow manufacturer's operating instructions.
Make sure rivet nut correctly contacts component.
NOTE: According to the manufacturer, the tool shown is suitable for threads up to M12 (see S-Gate/dealer's equipment catalog).