65 77 720 Removing and installing (replacing) left B-pillar sensor (Cooper 2-door hatchback models, 2020-2023)
IMPORTANT:
READ AND COMPLY WITH NOTES ON PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)
!
WARNING:
OBSERVE THE SAFETY REGULATIONS FOR AIRBAGS
!
Failure to observe correct procedures can deploy the airbag and cause injuries.
Failure to observe correct procedures can deploy the airbag and cause injuries.
Preliminary work needed:
- DISCONNECTING BATTERY GROUND LEAD and cover
- Remove SIDE TRIM PANEL .
REMOVAL:
Unfasten plug connection (1) and disconnect.
Remove screw (2).
Remove sensor (3).
INSTALLATION:
Position sensor (3).
Tighten screw (2).
Tightening torque 65 77 3AZ .
Join and lock plug connection (1).
Required reworking:
- CONNECTING BATTERY GROUND LEAD .
- Install SIDE TRIM PANEL .