66 20 537 Removing and installing/replacing one rear middle right ultrasonic sensor (Cooper 4-door hatchback and Cooper 2-door hatchback, 2020-2023)

WARNING: Risk of burning!
Work on the exhaust system may only be carried out when it has cooled down!

REMOVAL:

Unfasten plug connection (1) and disconnect.

Unlock latches at marked points.

Remove ultrasonic sensor (2) from holder.

Courtesy of BMW OF NORTH AMERICA, INC.

INSTALLATION:

NOTE: Make sure rubber ring (1) is correctly seated on ultrasonic sensor (2).

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Before installation of ultrasonic sensor (2) on wiring harness, clean plug connection!
Safety catches (1) of ultrasonic transducer (2) must engage exactly in mountings (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Engage ultrasonic sensor (2) in holder.

Join and lock plug connection (1).

Courtesy of BMW OF NORTH AMERICA, INC.