65 77 016 Removing and installing/replacing airbag control unit (Cooper 4-door hatchback and Cooper 2-door hatchback, 2020-2023)

WARNING: NOTE AIRBAG SAFETY REGULATIONS! .
Failure to observe correct procedures can deploy the airbag and cause injuries.

Attention!

Read and comply with NOTES on protection against electrostatic damage (ESD protection).

Preliminary work needed:

Removal:

Detach cable clip (1).

Release nut (2) and screw (3).

Take off holder (4).

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nuts (1).

Unlock plug connections (2) and disconnect.

Remove airbag control unit (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Position airbag control unit (3).

Tighten down nuts (1).

Tightening torque 65 77 1AZ .

Join and lock plug connections (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Position holder (4).

Tighten nut (2) and bolt (3).

Attach cable clip (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Install CENTER CONSOLE .
Connect NEGATIVE BATTERY CABLE .
Run the service function to adjust the sensors for the driving dynamics as follows:

Replacement: