61 31 052 Removing and installing/replacing center console control panel (Cooper 4-door hatchback and 2-door hatchback, 2020-2023)

Preliminary work needed: 

• Remove IHKA CONTROL PANEL .

Removal: 

Remove screw (1).

Unclip center console control panel (2) from center console.

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and disconnect connector (1) on center console control panel (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Connect connector (1) to center console control panel (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Clip center console control panel (2) into center console.

Tighten screw (1).

Tightening torque 61 31 4AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Install IHKA CONTROL PANEL .