51 31 045 Removing and installing/replacing trim for left or right A-pillar (Cooper 2-door hatchback models, 2020-2023)

Preliminary work needed:

Removal:

Unclip roof trim strip (1) outwards in front area.

Courtesy of BMW OF NORTH AMERICA, INC.

Release door weather strip in area of A-pillar.

Unscrew the screws (1).

Release cover (2) at clips (3) and remove.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

NOTE: If necessary, release clips (2) from A-pillar (1).
Seal (3) must not be damaged.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Replace faulty grommets (1) on A-pillar (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Parts: Replace faulty clips (1 and 2).

Make sure the installation location of clips (1 and 2) is correct.

Clip mount (3) remains free.

Courtesy of BMW OF NORTH AMERICA, INC.

Position trim (2) with clips (3) on body and clip in.

Tighten down screws (1).

Fasten door weather strip in area of A-pillar.

Courtesy of BMW OF NORTH AMERICA, INC.

Clip roof trim strip (1) into clamps (2).

Clip roof trim strip (1) into trim (3) in area (A).

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: