Install bumper cover, front
- Only in vehicles with build level up to: March 2021
- Position the bumper cover (2) with the help of another person.
- Connect all plug connections depending on equipment specification and lock.
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Bumper cover to front panel | ||
|---|---|---|
| M6x20 screw | Tightening torque | 6 Nm |
- Only in vehicles with build level starting from: March 2021
- Position the bumper cover (2) with the help of another person.
- Connect all plug connections depending on equipment specification and lock.
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Bumper cover to front panel | ||
|---|---|---|
| M6x20 screw | Tightening torque | 6 Nm |
NOTE:
Perform the steps on the right and left side.
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Wheel arch cover | ||
|---|---|---|
| screw | Tightening torque | 2.6 Nm |
| Plastic nut | Tightening torque | 2.6 Nm |
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Lower front bumper panel | ||
|---|---|---|
| screw | Tightening torque | 3 Nm |
- Only in vehicles with build level up to: March 2021
NOTE:
Perform the steps on the right and left side.
- Position wheel arch trim (1) and engage it into detents (2) and clips (3).
- Only in vehicles with build level starting from: March 2021
NOTE:
Perform the steps on the right and left side.
- Position wheel arch trim (1) correctly and engage it into clips (2).
- Engage wheel arch trim (1) into detents along the dotted line.