- Only in vehicles with build level up to:
March 2021
- Position the bumper cover (2) with the help of another person.
- Connect all plug connections depending on equipment specification and lock.
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATION
| Bumper cover to front panel |
| M6x20 screw |
|
| |
Tightening torque |
| |
6 Nm |
 Courtesy of BMW OF NORTH AMERICA, INC.
|
- Only in vehicles with build level starting from:
March 2021
- Position the bumper cover (2) with the help of another person.
- Connect all plug connections depending on equipment specification and lock.
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATION
| Bumper cover to front panel |
| M6x20 screw |
|
| |
Tightening torque |
| |
6 Nm |
 Courtesy of BMW OF NORTH AMERICA, INC.
|
NOTE:
Perform the steps on the right and left side.
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATION
| Wheel arch cover |
| screw |
|
| |
Tightening torque |
| |
2.6 Nm |
| Plastic nut |
|
| |
Tightening torque |
| |
2.6 Nm |
 Courtesy of BMW OF NORTH AMERICA, INC.
|
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATION
| Lower front bumper panel |
| screw |
|
| |
Tightening torque |
| |
3 Nm |
 Courtesy of BMW OF NORTH AMERICA, INC.
|
- Only in vehicles with build level up to:
March 2021
NOTE:
Perform the steps on the right and left side.
- Position wheel arch trim (1) and engage it into detents (2) and clips (3).
 Courtesy of BMW OF NORTH AMERICA, INC.
|
- Only in vehicles with build level starting from:
March 2021
NOTE:
Perform the steps on the right and left side.
- Position wheel arch trim (1) correctly and engage it into clips (2).
- Engage wheel arch trim (1) into detents along the dotted line.
 Courtesy of BMW OF NORTH AMERICA, INC.
|