Sticking on the model designation
- Position sticker (1) in the center of the recess in the rear spoiler.
- Secure sticker (1) with adhesive strips (2) to prevent it from slipping.
- Fold the sticker upwards (1) and detach the protective film.
- Hold sticker (1) at the corners and fold it down.
Place sticker (1) on the rear spoiler without any creases.
- Press with a finger in area (2).
- Trace letters (1) with a finger and press on the film.
- Press on letters (1) fully with a squeegee.
For example, the plastic squeegee (Gold) manufactured by 3M can be used.
- Detach backing film (2) and adhesive strip (3) carefully.