5171 Gaskets And Loose Body Parts
5171 GASKETS AND LOOSE BODY PARTS - TIGHTENING TORQUE SPECIFICATION
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Wheel arch cover to body | F54/F55/F56/F57/F60 | 3 Nm | ||
| 2AZ Lashing point to body | F54/F55/F56 | 19 Nm | ||
| 3AZ Rear spoiler to trunk lid (middle) | F55/F56 | 3 Nm | ||
| 4AZ Rear spoiler to trunk lid (outer) | F55/F56 | 2 Nm | ||
| 5AZ Underbody protection | F54/F55/F56/F57/F60/F45/F46/F48/F49/F52 | 3 Nm | ||
| F52 | M6 | 8 Nm | ||
| 6AZ Air flap control to support | F54/F55/F56 | 6 Nm | ||
| 7AZ Rear spoiler to body | F54 | 3 Nm | ||
| 8AZ Lower part of rear spoiler to body | F54 | 7.6 Nm | ||
| 9AZ Bulkhead cover | F54/F48/F49/F60 | 3 Nm | ||
| 10AZ Mounting from hood seal, sideways | F48/F49/F60 | 3 Nm | ||
| 11AZ Vehicle underbody cover at side | F52/F57 | Hexagon screw | 3 Nm | |
| Plastic nut | 2.6 Nm | |||
| 12AZ Front cowl panel seal on cowl panel | F57 | 3 Nm | ||
| 13AZ Base plate to body | F60 | 8 Nm |
5171 TIGHTENING TORQUE OVERVIEW
| Air duct to deformation element/cross connection | ||
| M6x20 screw | Tightening torque | 6 Nm |
| Battery cover to tension strut/trim panel | ||
| Tightening torque | 2.8 Nm | |
| Brake ventilation duct to holder | ||
| screw | Tightening torque | 4 Nm |
| Bumper cover to front panel | ||
| M6x20 screw | Tightening torque | 6 Nm |
| Lower front bumper panel | ||
| screw | Tightening torque | 3 Nm |
| Second bulkhead | ||
| screw | Tightening torque | 5 Nm |
| Tension strut to battery tray | ||
| M8 | Tightening torque | 19 Nm |
| Wheel arch trim panel to bumper panel | ||
| Screw | Tightening torque | 2.5 Nm |
| Wiring harness holder to second bulkhead | ||
| screw | Tightening torque | 1.5 Nm |