65 77 720 Removing and installing (replacing) left B-pillar sensor (Cooper 4-door hatchback models, 2020-2023)
IMPORTANT:
READ AND COMPLY WITH NOTES ON PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)
!
WARNING:
ADHERE TO THE AIRBAG SAFETY REGULATIONS
!
Failure to observe correct procedures can deploy the airbag and cause injuries.
Failure to observe correct procedures can deploy the airbag and cause injuries.
Preliminary work needed:
- DISCONNECTING BATTERY GROUND LEAD and cover
- Remove TRIM PANEL FOR DOOR PILLAR .
Removal:
Unfasten plug connection (1) and disconnect.
Remove screw (2).
Remove sensor (3).
Installation:
Position sensor (3).
Tighten screw (2).
Tightening torque 65 77 3AZ .
Connect and lock plug connection (1).
Required reworking:
- Connect BATTERY GROUND LEAD .
- Install TRIM PANEL FOR DOOR PILLAR .