66 20 535 Removing and installing/replacing rear right ultrasonic sensor (Cooper 4-door hatchback and Cooper 2-door hatchback, 2020-2023)

REMOVAL:

Remove screw (1).

Place wheel arch cover (2) slightly to one side.

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1) and disconnect.

Unlock latches at marked points.

Remove ultrasonic sensor (2).

Courtesy of BMW OF NORTH AMERICA, INC.

INSTALLATION:

NOTE: Make sure rubber ring (1) is correctly seated on ultrasonic sensor (2).

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Before installation of ultrasonic sensor (2) on wiring harness, clean plug connection!
Safety catches (1) of ultrasonic transducer (2) must engage exactly in mountings (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Engage ultrasonic sensor (2) in holder.

Join and lock plug connection (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Position wheel arch cover (2) correctly.

Tighten screw (1).

Courtesy of BMW OF NORTH AMERICA, INC.