5161 Reinforcement, Body
TIGHTENING TORQUE SPECIFICATION (BODY REINFORCEMENT)
| 1AZ Torsion strut to mounting | F45/F46/F48/F49/F54/F52/F60 | M12X1.5X48 | Replace screws | |
| Joining torque | 100 Nm | |||
| Angle of rotation | 90° | |||
| 2AZ Cross-brace to Firewall | F45/F46/F48/F49/F60/F52 | Replace nut | ||
| Joining torque | 56 Nm | |||
| Angle of rotation | 45° | |||
| 3AZ Strut brace to support bearing | F45/F46/F48/F49/F60/F52 | Replace screw | ||
| Joining torque | 56 Nm | |||
| Angle of rotation | 90° | |||
| 4AZ Front strut brace to shock tower (dome-dome-strut) | F48/F49/F60 | Replace screw | ||
| Joining torque | 28 Nm | |||
| Angle of rotation | 180° | |||
| 5AZ Torsion strut to mounting | F57 | Hexagon screw M12X1.5X48 |
Replace screws | |
| Joining torque | 100 Nm | |||
| Angle of rotation | 90° | |||
| Torx screw M10X16 | 38 Nm |
TIGHTENING TORQUE SPECIFICATION
| Connecting support to rear console tunnel | ||
| Flat-head screw M8x16 | Tightening torque | 19 Nm |
| Torsion strut to side member | ||
| M12 | Joining torque | 100 Nm |
| Angle of rotation | 70° | |