Installing the idler pulley
- Insert and install the idler pulley (2) .
- Tighten down screw (1) .
TIGHTENING TORQUES SPECIFICATION
| Idler pulley to belt tensioner | ||
|---|---|---|
| M8 | tightening torque | 28Nm |
Follow-up work
- Refer to INSTALLING THE ALTERNATOR .
- Refer to INSTALLING DRIVE BELT .
- Refer to IF INSTALLED: INSTALLING RIGHT BRAKE VENTILATION DUCT .
- Refer to INSTALLING WASHER FLUID RESERVOIR .
- Refer to INSTALLING THE FRONT RIGHT WHEEL ARCH COVER .
- Refer to INSTALLING THE FRONT RIGHT WHEEL .
- Refer to INSTALLING THE INTAKE PLENUM .
- Refer to INSTALLING THE SERVOMOTOR FOR THE ECCENTRIC SHAFT .
- Refer to INSTALLING THE TANK VENT VALVE .
- Refer to INSTALLING CROSS CONNECTION .
- Refer to INSTALLING INTAKE SILENCER HOUSING .
- Refer to INSTALLING INTAKE PORT .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .