22 11 095 Removing and installing/replacing holder with rubber mount (Countryman base FWD, Countryman S FWD, Countryman base ALL4 AWD, Countryman S ALL4 AWD, Countryman JCW ALL4 AWD)

Preliminary work needed: 

• Remove front UNDERBODY PROTECTION .

Removal: 

Undo bolts (1) and remove holder (2) with rubber mount.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Install holder (1) with rubber mount.

Tighten down screws (2).

Tightening torque 22 11 4AZ .

Tighten screw (3).

Tightening torque 22 11 5AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Install front UNDERBODY PROTECTION .