Removing both actuators
Preliminary work
- Refer to REMOVING REAR HOOD SEAL .
- Refer to REMOVING FRONT WINDSHIELD PANEL COVER .
- Refer to REMOVING THE UPPER BULKHEAD COVER PANEL .
- Refer to REMOVING SUSPENSION CROSS-BRACE .
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING INTAKE PORT .
- Refer to REMOVING INTAKE SILENCER HOUSING .
- Refer to REMOVING CLEAN AIR PIPE .
WARNING:
Hot surfaces
.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
NOTE:
RISK OF DAMAGE
Electrostatic discharge .
Damage to or destruction of electrical components .
Electrostatic discharge .
Damage to or destruction of electrical components .
- Leave the electrical components in their original packaging until they are being installed. Only use the original packaging for returning the product. Always package removed components straight away.
- Read and comply with user information on using the associated special tool 12 7 060.
- Only tap the housings of electrical components. Do not tap pins or multi-pin connectors directly.
- Wear electrically conductive clothing and antistatic shoes (with ESD symbol).
- For additional information see: 61 35... NOTES ON ESD (ELECTROSTATIC DISCHARGE) PROTECTION
- Unlock and release locking mechanisms in marked areas.
- Remove the wiring harness section (1) and put to one side.
- Unlock and loosen connector (1).
- Unlock and loosen connector (2).
- Unlock actuator (1) for intake side with special tool 2 360 895 in arrow direction and release .
- Feed out actuator (1) for intake side and remove.
- Unlock actuator (1) for exhaust side with special tool 2 360 895 in arrow direction and release.
- Feed out actuator (1) for exhaust side and remove.