52 26 022 Removing and installing/replacing striker for left or right rear seat backrest
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
- Microencapsulated screws must be coated with Loctite if they are to be reused
- Screw connection must be completed within 20 min. (start of hardening)
- Microencapsulated screws must not be retightened
- Thread of nut must be cleaned beforehand in event of repeated use
Necessary preliminary tasks:
- Remove LUGGAGE COMPARTMENT WHEEL ARCH PANEL
- Fold down backrest
Removal:
Release screws (1).
Remove striker (2).
Installation:
Position striker (2).
Tighten down screws (1).
Tightening torque 52 26 3AZ .