61 31 362 Removing and installing (replacing) the receiver of the radio remote control

WARNING: This page is about a different variant/trim than selected.

Attention !

Necessary preliminary tasks:

Removal:

Unlock and disconnect the connector (1).

Release expanding rivet (2) and remove the receiver (3).

Fig 1: Removing Expanding Rivet

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

NOTE: Position the receiver (1) in a way that the positioning pin (2) engages in the matching bore hole.

Fig 2: Positioning Pin With Bore Hole

Courtesy of BMW OF NORTH AMERICA, INC.

Install the receiver (3) and secure with expanding rivet (2).

Connect the connector (1).

Fig 3: Removing Expanding Rivet

Courtesy of BMW OF NORTH AMERICA, INC.