61 31 117 Removing and installing/replacing power window switch (driver's/passenger's side)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

IMPORTANT: Carry out the following operation carefully so as to avoid damaging the door trim panel and switch.
If necessary, tape off working area.

Removal:

Lever power window switch (1) out of armrest (2) in direction of arrow using special tool 00 9 327 .

Disconnect connector underneath and remove power window regulator switch (1).

Fig 1: Removing Power Window Regulator Switch

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release latch mechanisms on both sides and feed power window switch (1) out of trim (2).

Join switch replacement part for power window regulator (1) in cover (2).

NOTE: Ensure latch mechanism of switch for power window regulator (1) in cover (2) is correct.

Fig 2: Locating Power Window Regulator Switch

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

NOTE: The guide (1) and latch mechanisms (2) on the trim (3) must not be damaged or missing.

Fig 3: Locating Trim Guide And Latch Mechanisms

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connector.

Join power window regulator switch (1) in armrest (2) in direction of arrow.

NOTE: Make sure that the power window switch is correctly seated in the armrest.

Fig 4: Installing Power Window Regulator Switch Into Armrest

Courtesy of BMW OF NORTH AMERICA, INC.