61 31 043 Removing and installing roof switch center: Notes

WARNING: This page is about a different variant/trim than selected.

Special tools required:

00 9 325

Attention !

Follow INSTRUCTIONS for handling light bulbs (interior lighting).

Attention !

Read and comply with notes on ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Removal:

Carefully unclip the trim (1) with the special tool 00 9 325 .

Remove the roof switch cluster (2).

Fig 1: Removing Roof Switch Cluster

G11649832

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock latch mechanisms on both sides with screwdriver.

Remove roof switch cluster (1) from headlining (2).

Unlock and disconnect connector on rear side of roof switch cluster (1).

Fig 2: Removing Roof Switch Cluster From Headlining

G11649833

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Connect connector on rear side of roof switch cluster (1).

Join roof switch cluster (1) in headlining (2).

NOTE: Ensure roof switch cluster (1) is correctly fitted and engaged.

Fig 3: Removing Roof Switch Cluster From Headlining

G11649833

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Guides and retaining lugs (1) on cover (2) must not be damaged or missing.

Fig 4: Locating Cover Guides And Retaining Lugs

G11649835

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully join and clip in the trim (1) on the roof switch cluster (2).

NOTE: Ensure cover (1) is correctly fitted and engaged on roof switch cluster (2).

Fig 5: Removing Roof Switch Cluster

G11649836

Courtesy of BMW OF NORTH AMERICA, INC.

Attention !

Disconnecting the plug connection for the SOS emergency call button results in fault entries in the telephone control unit (restriction in the emergency call system).

After installation, read out fault memory and if necessary delete fault code entry.