61 31 037 Removing and installing/replacing light control unit

WARNING: This page is about a different variant/trim than selected.

NOTE: When working on trim panel components, make sure that the sensitive surfaces are not scratched or damaged.

Necessary preliminary tasks:

Removal:

Loosen the screws (2) on the light operating unit (1).

Remove the light operating unit (1) from the bottom instrument panel trim panel (3).

Fig 1: Light Operating Unit Screws Location

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert the light operating unit (1) into the bottom instrument panel trim panel (3).

Tighten down screws (2).

Tightening torque 61 31 1AZ .

Fig 2: Light Operating Unit Screws Location

Courtesy of BMW OF NORTH AMERICA, INC.