61 31 021 Remove and install/replace ring aerial

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Removal:

If required, unlock and disconnect connector.

Unlock latch mechanism and pull ring aerial (1) upwards out of steering column shroud (2).

Fig 1: Pulling Ring Aerial Out Of Steering Column Shroud

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Join ring aerial (1) in steering column shroud (2).

If required, connect connector.

NOTE: Make sure ring aerial (1) is correctly locked in steering column shroud (2).

Fig 2: Pulling Ring Aerial Out Of Steering Column Shroud

Courtesy of BMW OF NORTH AMERICA, INC.