61 33 060 Removing and installing/replacing both fanfare horns

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Removal:

Unlock and disconnect connector (1) on cable clip.

Fig 1: Cable Clip Connector Location

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and feed out holder with fanfares (2) downwards.

Fig 2: Fanfares Screws Location

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Feed in holder with fanfares (2) from below and tighten with screws (1).

Tightening torque: 6 Nm.

Fig 3: Fanfares Screws Location

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connector (1) to cable clip.

Fig 4: Cable Clip Connector Location

Courtesy of BMW OF NORTH AMERICA, INC.