61 35 360 Removing and installing control unit for camera-based driver support systems (KAFAS)

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Necessary preliminary tasks:

Removal:

Release latch mechanism on equipment holder.

Feed out KAFAS control unit (1) from equipment holder (2).

Fig 1: Locating KAFAS Control Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock connector (1) on KAFAS control unit (2) and disconnect.

Fig 2: KAFAS Control Unit Connector Location

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Connect connector (1) to KAFAS control unit (2).

Fig 3: KAFAS Control Unit Connector Location

Courtesy of BMW OF NORTH AMERICA, INC.

Join KAFAS control unit (1) in equipment holder (2).

NOTE: Ensure latch mechanism of KAFAS control unit (1) is correct in equipment holder (2).

Fig 4: Locating KAFAS Control Unit

Courtesy of BMW OF NORTH AMERICA, INC.