61 35 095 Removing and installing/replacing control unit/module for seat heating

WARNING: This page is about a different variant/trim than selected.

Attention !

Read and comply with NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Removal:

NOTE: To facilitate installation/removal of control unit, move seat upwards and to the rear fully.

Fig 1: Removing Control Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect all connectors (1).

Press control unit/module for seat heating (2) first in direction of arrow (4) and then simultaneously in direction of arrow (5) and feed out of the plastic holder (3).

Installation:

Feed control unit/module for seat heating (2) into the plastic holder (3) first in direction of arrow (4) and then engage in direction of arrow (5).

Connect all connectors (1).

Fig 2: Installing Control Unit/Module For Seat Heating Into Plastic Holder

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Make sure control unit/module for seat heating (2) is correctly engaged.