41 11 072 Replacing engine support with front right wheel arch in front of bulkhead

WARNING: This page is about a different variant/trim than selected.

Observe special procedure for vehicle identification number (order body new part with vehicle identification number if required).

Refer to procedure in repair instructions ENGINE SUPPORT IN FRONT OF BULKHEAD WITH LEFT WHEEL ARCH and transfer schematically to the vehicle.

Preparation of new part:

Prepare new parts in areas (1) up to (3) for joints through welding.

NOTE: All 3 panels must be welded to each other in areas (3).

Increase size of holes in areas (3) (open WELDED CONNECTIONS ) top Ø 10 mm. Transfer holes to new engine support internal part and drill.

Fig 1: Weld-Joints And Bore Hole Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Install new parts and reinforcement plate to fit with alignment bracket or universal fixture.

Fig 2: Weld-Joints And Bore Hole Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Weld new parts in areas (1) to (3).