(41 34 060 Stripping operation - Replacing tail panel outer section and inner section)

WARNING: This page is about a different variant/trim than selected.

NOTE: Owing to the different engine variants and equipment specifications, not all the components are taken into consideration.

The following list essentially represents the disassembly sequence.

Remove complete exhaust system (18 00 020)
Remove heat shield for rear silencer
Remove bumper panel (51 12 156)
Remove bumper support (51 12 050)
Remove guide for rear left and right bumper (51 12 828)
Remove luggage compartment floor trim panel (51 47 101)
Remove left luggage compartment wheel arch panel (51 47 151)
Remove right luggage compartment wheel arch panel (51 47 161)
Remove tail panel trim at top (51 46 050)
Remove and install tailgate striker (51 24 130)
Release seal for rear lid

Release screws (1) and remove shaft (2).

Fig 1: Screws And Shaft

Courtesy of BMW OF NORTH AMERICA, INC.

Release latch mechanisms and remove rear ventilation (1).

Release nuts and remove heat shield (2).

Fig 2: Rear Ventilation, Heat Shield, And Underbody Panelling

Courtesy of BMW OF NORTH AMERICA, INC.

Release nuts and remove underbody panelling (3).

Installation note:

The rear ventilation must not be damaged! (watertightness).

All latch mechanisms must engage audibly.